This Victorian tiled hallway floor at a property on the outskirts of Thirsk was approximately 135 years old and was in need of deep cleaning and repair. As far as the owners were aware it had never been professionally cleaned but was sealed many times before with some type of varnish/linseed oil.
Unsurprisingly for its age the tiles were fairly worn and unfortunately had some suffered damaged due to the installation of heating pipework that was run under the floor. This area had simply been backfilled with cement and my client asked for this to be replaced with tiles that match the existing type and pattern. The was floor was then to be restored to the best condition possible given its age.
 |
 |
I’ve worked on these sorts of issues before so more than happy to take on the project. It took a little time to track down the replacement tiles but once I had everything costed, I was able provide an accurate quote to the owner who gave the go ahead to start the work.
Cleaning and Repairing a Victorian Tiled Hallway
To start I gave the whole floor a deep clean with a strong dilution of Tile Doctor Remove and Go combined with Tile Doctor Pro-Clean to remove the several coatings from the tiles worked in with coarse 100 and 200-grit diamond pads fitted to a rotary machine. I also used hand-held diamond blocks around the edges. The soiling was then rinsed off with water and extracted with a powerful wet vacuum.
Next, I turned my attention to the damaged areas where the tiles had been dug out and backfilled with cement. This cement was at the same height as the floor, so it had to be carefully removed and then replaced with a lower screed mix with protection over the pipes to stop any corrosion.
 |
 |
Once the screed had set the area was re-tiled using the replacements I had managed to source earlier making various cuts as required to achieve the original geometric pattern.
The repaired and cleaned floor was then left for approximately four days until it was dry enough to seal. These old floors don’t have the benefit of a damp proof course and sealers work best when applied to dry tiles, so it is always worth waiting if there is any doubt.
Sealing a Victorian Tiled Hallway
On my return I used a moisture meter to confirm the floor was dry and ready to be sealed.
The hallway is above ground level and away from the problems of rising moisture, however it is important to use a breathable sealer on these old floors that will allow any moisture to evaporate at the surface and not get trapped underneath where it could cause problems.
So, for this floor we used Tile Doctor Seal and Go Extra which is breathable and results in a nice shine finish which the client requested. Four coats where needed before the tiles were fully sealed.
The client was very pleased with the result and even added a tip to their payment.
The new sealer will keep the dirt on the surface of the floor where it can be easily cleaned away. For which I recommend using Tile Doctor Neutral Tile Cleaner, it’s a gentle but effective product that won’t impact the sealer.
Source: Victorian Floor Cleaning and Restoration Services in Thirsk North Yorkshire